3,004 recalls found in Vehicles — Medium risk
Defect: Feed Knob Starter switch support spring failure could possibly result in ignition off whilst vehicle is in motion. Remedy:…
Defect: The air bag control unit may have been equipped with a defective sensor for the rollover detection. Remedy: The…
Defect: The factory Electronic Control Unit programming may cause the engine to after fire when Kawasaki Quick Shifter is used…
Defect: On affected vehicles the e-call service may not function Remedy: Update the Online Control Unit software on affected vehicles…
Defect: On affected vehicles the e-call service may not function Remedy: Update the Online Control Unit software on affected vehicle.…
Defect: Contact could occur between brake hoses and the rear segment of the front axle wing panel liner resulting in…
Defect: The brake pad could detach from its retaining clip and fall away from the brake disc Remedy: Fit a…
Defect: Possibility of humidity ingress in the Bowden cables of the doors due to missing seals. Remedy: Remove cables and…
Defect: A small number of vehicles may have an adhesive bond between the sunroof and the vehicle body which does…
Defect: When the vehicle is turned off if moisture enters the ABS module it could cause an electrical short. Remedy:…
Defect: The wheel arch liner on the front axle could touch and chafe the flexible brake hose. Remedy: Check the…
Defect: The tightness of the quick connector of the fuel supply line may not be ensured. Remedy: The fuel supply…
Defect: The brake pedal deflects under braking pressure and contacts the Skid Plate which inhibits rear wheel braking performance. Remedy:…
Defect: The steering geometry could be incorrectly set due to an incorrectly calibrated setting rig in the manufacturing plant. Remedy:…
Defect: The steering geometry could be incorrectly set due to an incorrectly calibrated setting rig in the manufacturing plant. Remedy:…
Defect: Vehicles may not comply with specific emissions criteria. Remedy: Carry out a SOPS software conversion or evidence exemption compliance…
Defect: The front brake pads could have potential issues involving detachment of brake pad friction material from the back plate.…
Defect: Corrosion due to salt may cause brake bind. Remedy: Inspect and clean replace the seals or callipers as required.…
Defect: The friction material might separate from the plates of the brake pads due to a non-conformity. Remedy: Replace the…
Defect: It is possible that gear oil may escape due to a faulty welded joint on the gearbox oil line.…