3,142 recalls found β Medium risk
Defect: P-Clip holding the Starter Motor cable may chafe through the outer insulation of the cable and cause a possible…
Defect: The front frame suspension arm anchor bolt torque could be insufficient. Remedy: Owners instructed to not drive their vehicle.…
Defect: Drivers airbag may not deploy correctly Remedy: Replace Driver air bag assembly Vehicles affected: 219738 DVSA Recall Reference: R/2020/013…
Defect: It may be possible that the ball type tow-bar does not meet the requirements of the fatigue strength. Remedy:…
Defect: Insufficient clearance between transmission harness and catalytic convertor. Remedy: Inspect the transmission wiring harness reposition harness or replace if…
Defect: A rear seat longitudinal adjustment lever may not lock properly. Remedy: Check affected seat frames and replacing them if…
Defect: A rear seat longitudinal adjustment lever may not lock properly. Remedy: Check affected seat frames and replacing them if…
Defect: The front hub assembly fixing on to the front suspension damper may not be correct to specification. Remedy: Check…
Defect: The front hub assembly fixing on to the front suspension damper may not be correct to specification. Remedy: Check…
Defect: An electrical contacting inside the engine control unit might not meet the specification Remedy: Replace the engine control unit…
Defect: A fuel pump flange assembly that when exposed to certain chemicals may degrade over time. Remedy: Install a model…
Defect: A curtain airbag which cannot be guaranteed to provide the intended protection in the event of an accident. Remedy:…
Defect: The seat frame may not have been bolted correctly to the seat rail on the driver and/or front passenger…
Defect: The absorption of moisture into the driverοΏ½s airbag propellant could lead to slow deployment or inflator rupture. Remedy: Replace…
Defect: When using the engine brake/intarder or third brake in motion the brake lights are not activated Remedy: Vehicle software…
Defect: In very rare cases welding beads were not always completely removed in the cleaning process during battery production. Remedy:…
Defect: In very rare cases welding beads were not always completely removed in the cleaning process during battery production. Remedy:…
Defect: The second seat row might not be correctly engaged in the seat rail on one side. Remedy: Check the…
Defect: Vehicle shutdown sequence may initiate without providing reasonable rider indication. Remedy: Updating of the on-board software. Vehicles affected: 30…
Defect: Prop shaft centre bearing support brackets are potentially under torqued in production Remedy: Check the fixing bolts of affected…